Performance Recumbent Inc.

 

 

 

 

 

 

 

The swb recumbent designed for use on street and surface road. The bents is not recommended for downhill

Competition, stunt riding, or any aggressive off-road riding. Make sure all quick release and screws, nut locked

and safety lock before use the bike.

※ Rider Weight Limit: 110 kgs. X-Seam: Standard 36' ~46'

Over standard, Rider needs Special Order.

Bicycle Safety

  1. Always wears an approved bicycle helmet.

  2. Obey all traffic laws.

  3. Make sure rider can reach brake levers easily.

  4. Make sure brakes work properly and that the bicycle works perfectly.

  5. Do not weave in and out of traffic or swerve from side to side.

  6. Do not "stunt" ride or race in traffic.

  7. Never ride two people on a bicycle designed for one.

     (Except specially designed and properly installed child carriers.)

  8. Mount loads securely. Never carry package that interfere with brakes or vision.

  9. Be alert for cars pulling out into traffic. Keep a sharp watch for the sudden opening of car doors.

10. Always have lights on at night, and install reflectors properly.

11. Slow down when approaching hikers or equestrians.

12. Use appropriate hand -signals for turning and stopping.

13. If the roads are icy, do not to ride your bike at all.

14. Never allow oil, grease, wax etc. on the bike pads, wipe the wheel rims dry

      before riding. Make sure the brake pads do not rub the tires.

15. Keep the chain well lubricated.

** ALWAYS RIDE CAREFULLY **

Inspection & Maintenance

1.General

Nuts and bolts should be retightened every 1 ~ 2 weeks. Check frequently for damaged parts, fork

alignment, and positioning of all components.

2. Brakes

Keep brake shoes centered on rim surface to avoid contact with tire and adjusted 3 ~ 4 mm from

Inspect them for wear, replacing when necessary. Wipe off any oil or dirt that accumulates on rims.

3.Control Cables

Cables stretch with use. Inspect them regularly, taking up slack and replacing when worn or damage

never allow cables to kink.

4.Front Fork

Bent or damaged forks should be repaired.

 

 

5. Head Set

Keep locknuts tight, making sure there is no play in the bearings. The fork should turn freely.

6.Front Wheel

Wheel should be centered in front fork with the quick release tight. Keep spokes and rim tube tight.

The hub is shielded against dirt and moisture, however, it should be inspected periodically,

especially after riding in rain. Remove the front wheel and turn the axle with your hands. It should

move freely, with very little friction or play.

Boom Tube Installation

To loosen the fix nut; adjust the boom tube Length of suitable size.

Be sure of tighten the fix nuts after adjustment.

Boom length adjusting, do not adjust over the limit line.

Pedal Installation

Be sure and clean the crank arm threads and grease the

threads on the pedal before mounting. Fit the pedals on the

crank arms with a 15 mm wrench. The right pedal(marked R)

 screws onto the crank arm in a clockwise direction

and the left pedal(marked L) screws on , in a counter

clockwise direction.

Special Precaution for Wet Road Conditions

Braking power is reduced in wet conditions and special care must be taken to stop safety.

Proper brake adjustment and cable lubrication will help, but the major responsibility lies

with the rider. Since increased lever force is required, ride more slowly and apply brakes

sooner than would be necessary on dry roads.

☆ When you wear trousers, please tie the legs of trousers before riding.

Warranty

Our bents warrants the replacement of original components of our bents, for defects in material l and / or workmanship

according to the following conditions and limitations: The frame and fork are warranted to the original purchase for 3 years,

regardless of material, all other bents parts specified as equipment on our recumbent are warranted by the

original manufacturer. Please contact them directly, or via your authorized dealer, for warranty service.

Labour and transportation charges are not included.

This warranty is limited to the original retail purchaser only. Proof of purchase is required to validate protection under

this limited warranty. Normal wear, accident, abuse, neglect, improper assembly ,improper maintenance by other

than an authorized dealer or use of parts or devices not consistent with the use originally intended for the recumbent

as sold are not covered by this warranty. This recumbent bike is not intended for use in stunt riding, ramp jumping or

similar activities and this warranty is void where the recumbent bike has been used in any of these ways

Notice: The user assumes the risk of any personal injuries, damage to or failure of the bicycle and any other losses if

the recumbent is use in any competitive event, including bicycle racing, or in dirt biking or similar events.

IF YOU HAVE A PROBLEM

Please contact Authorized Performance Recumbent Dealers. Proof of purchase required. Or contact Performance Recumbent.

Performance Recumbent

Tel: 847-438-1666 Fax: 847-438-0202 E-mail: lampertdesigns@aol.com

http://www.getitbent.com/